Furious Mini RX for Frsky

生產商: FuriousFPV
The Furious Mini RX for Frsky is designed for plam size drones. Features Mini size : 17x24 mm. Light Weight : 2.5g (with antenna). Operating Range : 500m. S.Bus output...

有現貨

HK$175.00
The Furious Mini RX for Frsky is designed for plam size drones.

Features
  • Mini size : 17x24 mm.
  • Light Weight : 2.5g (with antenna).
  • Operating Range : 500m.
  • S.Bus output without inverted (don’t need inverted on FC).
  • 8 channel output.
  • Telemetry HUB.
  • Input voltage: 4-6V (normal 5V).
  • Compatibility: FrSky Taranis, Taranis Plus, & XJT module

Receiver Configuration in the Cleanflight / BetaFlight Configurator
  1. In the PORTS tab, select the UART that corresponds to the receiver (usually UART3 in F3 flight controllers) and activate Serial RX.
  2. Save by clicking on the Save and Reboot button.
  3. In the CONFIGURATION tab, in the Receiver Mode section, select RX_SERIAL.
  4. In the same tab, in the Serial Receiver Provider section, select SBUS.
  5. Save by clicking on the Save and Reboot button.
  6. Go to CLI and type the following commands :
    set sbus_inversion = OFF
    save
  7. The FC will reboot, applying the change.
  8. Go to the RECEIVER tab and make sure the receiver acts like it should.

Binding the receiver to the Frsky Taranis
  1. In the Taranis, go to MODE SETUP (page 2) in the model configuration.
  2. Go to Mode inside Internal RF and select D8.
  3. Press and hold the receiver bind button and plug your battery in to turn the receiver on.
  4. Release the button. A green LED lights up in the receiver.
  5. Going back to the Taranis and press BIND. The transmitter beeps, indicating it’s in bind mode.
  6. Wait for the green LED on the receiver to turn off. The binding procedure has finished.
  7. Exit the BIND mode in the Taranis.
  8. Unplug the battery to turn off the receiver.

Telemetry Configuration
  1. In the PORTS tab, select the UART that corresponds to the telemetry (usually UART2 in F3 flight controllers) and select FrSky in Telemetry. Leave the baudrate to AUTO.
  2. Go to CLI, and type the following commands
    set telemetry_inversion = OFF
    save
  3. The FC will reboot, applying the change.
  4. Make sure you’re getting the telemetry values in our Taranis correctly.

Just four wires to the FC


Saves a lot of space and weight on your drone




Product Status : In-Stock

Best Sellers