Holybro Kakute AIO V1.0 Flight Controller 3-in-1

Holybro Kakute AIO V1.0 Flight Controller 3-in-1

生產商: Holybro
Combining F3 Flight Controller, OSD, PDB (w/ Current Sensor) 3-in-1 With FC, OSD, PDB all integrated, Kakute AIO makes it simple and convenient to build up your drone.Only one VTX...

有現貨

HK$310.00
Combining F3 Flight Controller, OSD, PDB (w/ Current Sensor) 3-in-1
With FC, OSD, PDB all integrated, Kakute AIO makes it simple and convenient to build up your drone.Only one VTX module is needed to make a complete set of FPV Racing Drone.Minim OSD integrated; MWOSD Firmware preloaded; OSD Config port available; OSD interface highly customizable according to you own needs.

2 oz Copper PCB ensures the 120A Maximum Continuous Current.Dedicated Boot button for easy firmware flashing.Reinforced solder pads for trouble-free direct soldering.Extremely low profile design.

Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).PDB Maximum Continuous Current 120A.VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX. 5v/3.3v RX selectable.

Features
  • With FC, OSD, PDB all integrated.
  • Only one VTX module is needed to make a complete set of FPV Racing Drone.
  • Minim OSD integrated; MWOSD Firmware preloaded; OSD Config port available; OSD interface highly customizable according to you own needs.
  • 2 oz Copper PCB ensures the 120A Maximum Continuous Current.
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Extremely low profile design.
  • Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
  • PDB Maximum Continuous Current 120A
  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX. 5v/3.3v RX selectable.
  • Cleanflight support (RACE target).
  • BLHeli flashing supported by hardware
  • Raceflight ready
  • Betaflight ready
Specifications
  • STM32F303CCT6(256kB flash) 32-bit processor
  • MPU6050 Gyro/Accelerometer
  • ATmega328P with Arduino Bootloader(minim OSD)
  • MAX7456 Monochrome On-Screen Display(minim OSD)
  • FTDI Cable Compatible Pinout(minim OSD)
  • High quality, gold plated PCB
  • Micro USB connector for programming
  • Dimensions : 36x47.5x7mm (includes USB in height)
  • Mounting Holes : 30.5mm square to center of holes
  • Weight : 7g
Includes
  • 1x Kakute Flight Controller
  • 1x Quick Start Guide
  • 1x 80mm XT60 connector wire




Product Status : In-Stock

Useful Information :

Best Sellers