Holybro Kakute F3 Flight Controller

Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.Dedicated Boot button for easy firmware flashing.Reinforced solder pads for trouble-free direct soldering.Extremely low profile design.Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).

VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.Cleanflight support (RACE target).BLHeli flashing supported by hardware,Raceflight ready,Betaflight ready.

Features

• All solder pad hookup
• 6050 MPU (less susceptible to high frequency vibration)
• 42V input 5V 1.1A output regulator (note that up to 800ma is available external devices)
• Compatible with Clean/Beta,Race Flight
• 8mb black box built in

Specifications

• STM32F303CCT6(256kB flash) 32-bit processor
• MPU6050 Gyro/Accelerometer
• High quality, gold plated PCB
• Micro USB connector for programming
• Dimensions: 36x36x6mm (includes USB in height)
• Mounting Holes: 30.5mm square to center of holes
• Weight: 4.2g

Includes

• 1x 1x Kakute Flight Controller
• 1x 2.54mm Pitch pin headers
• Quick Start Guide

Product Status : In-Stock

Useful Information :