KISS 18A OneShot ESC V1.1

生產商: Kiss
K.I.S.S. - Keep it super simple. Smallest ESC in its class, just 2g bare PCB. Hardware and Software are developed for each other, all Parameters are optimized, we are sure...

暫時缺貨

HK$155.00
K.I.S.S. - Keep it super simple.
Smallest ESC in its class, just 2g bare PCB.

Hardware and Software are developed for each other, all Parameters are optimized, we are sure you wont find another similar sized ESC which stays as cool and react as fast as this ESC at the same Ampere draw. Due to this special integration of hard and software some features are realized which allow the ESC to peform at a real high end level, no one reacts or brakes faster on a 14 Pole Motor (quite common) RPM up to 42.000 are supported, which is simply amazing. Given this high Pole count Motors arent a problem too for this ESC too.

Oneshot125 is an alternative PWM throttle Signal that is 8 times shorter/faster then the Standard 400-490Hz signals are. It is meant to be sent instantly after each FC controll loop to have the fastest possible ESC Response.

Oneshot Signal transmission is deeply integrated in the ESC and is a flawless experience by just setting one solder jumper (just optional, normal PWM works of course too). The Kiss ESC is easy to use, you wont need to do long test runs to find good settings, the Kiss ESC simply work.

Things to care for:
- Do not directly mount the ESC on conductive material such as carbon fiber or aluminum .
- Depending on the configuration, they also need GND connected instead of only the signal for FC because especially at 3.3V CPUs ( ARM Cortex for example ) a clean GND reference can be useful.
- This is a OPTO ESC, OPTO means this ESC lacks of the BEC Circuit, BEC circuit is to convert the battery's input voltage to 5V for powering the Receiver.

Features
  • Developed for Multicopter
  • Very small dimensions (12 x 23 mm)
  • Super light weight (2g only)
  • Precision speed control (about 950 steps)
  • adaptive Auto Timing
  • 32Khz PWM Frequenz
  • 50-500Hz input signal(PWM) or oneshot125 (up to 2000Hz)
  • no external Cap (electrolytic capacitor) is necessary **
  • fast reacting gas change
  • linear throttle response
  • Active freewheeling enabled (little diode losses resulting in higher efficiency)
  • very fast FET switching through the use of special gate drivers
  • Minimal dead time, setted adaptive
  • 2-4S LiPo capable
  • LED onboard

Jumper setup
  • JP1 open: normal PWM (50-500Hz)
  • JP1 closed: oneshot125 PWM
  • JP2 open: Motor rotates in one direction
  • JP2 closed: Motor rotates in the other direction

Includes :
  • 1 x K.I.S.S. 18A ESC (w/o cable)

Designed for :120~250 class Multi-rotors (e.g. Racing Drones)

Product Status : In-Stock

Best Sellers