KISS 2-5S 24A ESC Race Edition (v1.08)

KISS 2-5S 24A ESC Race Edition (v1.08)

生產商: Kiss
KISS ESC 2-5S 24A race edition - 32bit brushless motor ctrl Features 32-bit ARM Cortex MCU @48Mhz Telemetry capability (voltage, current, temp, rpm) Over-current protection (measures the current and reduces...

有現貨

HK$210.00
KISS ESC 2-5S 24A race edition - 32bit brushless motor ctrl
Features
  • 32-bit ARM Cortex MCU @48Mhz
  • Telemetry capability (voltage, current, temp, rpm)
  • Over-current protection (measures the current and reduces it to max 30A)
  • Over temperature protection (reduces the max power if hotter then 120°C)
  • Expanded adaptive auto timing (3,25-30° advance will be calculated on each commutation)
  • For Race Multicopters (24A continuous also with bad cooling *)
  • High max. RPM (450.000ERpm, 64.000Rpm with a 14Pol Motor)
  • Small size (19 x 27 mm)
  • Accurate RPM control (~ 950 steps)
  • No additional capacitor needed**
  • Very fast throttle response
  • Linear throttle response
  • Active freewheeling (low diode losses)
  • Regenerative braking
  • Fast FET switching because of the use of gate drivers
  • 2-5S LiPo**
  • Oneshot42, Oneshot125 and normal (25 ? 500Hz) PWM auto detected.
  • Operating voltage 6 - 25V
  • Maximum continuous current 24A
  • Instantaneous maximum current 30A active limited
  • 500,000 ERPM maximum field speed (use of 450,000 recommended)
(**) For very long LiPo power lines (more than 20cm) or for smoothing the power supply, attache a 100 - 400µF Low ESR 25V (or more) electrolytic capacitor to the power pads. Caution! When used with 5S lipo, the use of a electrolytic capacitor is recommended. (*) e.g. When mounted between two CF plates



Safety Warnings
  • Due to the regenerative braking, the KISS ESC should only be powered by LiPo batteries.
  • Never start a brush-less motor in your hands!
  • While starting up with propellers mounted, always care for distance yourself and objects
  • Never power up your ESC/speed controllers without a valid signal transmitter (receiver or FC) is connected.
  • The KISS ESC can be locally heated up to 80 ° C during operation!
  • While soldering do not connect a voltage source at the ESC / speed controller.
  • Some components on the KISS ESC can be destroyed by static charge. When handling such electronics, make sure to be grounded
KISS ESC24A re Knowledge Base

Includes :
  • 1 x K.I.S.S. 24A ESC (w/o cable)

Designed for :210~300 class Multi-rotors (e.g. Racing Drones)

Product Status : In-Stock

Useful Information :
   

Best Sellers