Matek F405-OSD Flight Controller

生產商: DYS
Features and Spec Target : MATEKF405 MCU: 168MHz STM32F405 IMU: 32K ICM20602 accelerometer/gyro (SPI) Support 32K Gyro update & 16K PID Loop OSD: BetaFlight OSD w/ AT7456E chip Blackbox: MicroSD...

有現貨

HK$256.00
Features and Spec
  • Target : MATEKF405
  • MCU: 168MHz STM32F405
  • IMU: 32K ICM20602 accelerometer/gyro (SPI)
  • Support 32K Gyro update & 16K PID Loop
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • VCP, UART1, UART2, UART3, UART4, UART5
  • Built in inverter for SBUS input (UART2-RX)
  • PPM/UART Shared: UART2-RX
  • Support SoftSerial on S5 & S6
  • Battery Voltage Sensor: 1:10
  • Currsnt Sensor: No (FCHUB-6S option)
  • BEC 5V & 10V: No (FCHUB-6S option)
  • LDO 3.3V: Max.300mA for Spektrum RX
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes
  • 36x36mm PCB with 30.5mm mounting holes
* If Gyro 32kHz & PID loop 16kHz, Blackbox logging rate 1kHz Max.





Included Flexible Flat Cable for FCHUB-6S board (* sold separately)




Wiring diagram (Click to enlarge)


Wiring diagram (Click to enlarge)


Non-inversion hacks on receiver
  • F405 MCU is not equipped with UART port inverters
  • Need non-inversion hacks to get the Frsky SmartPort working
  • Connect one of F4 UART-TXs to the non-inverted telemetry signal pad(Yellow circle)


Enable SoftSerial_TX on S5 or S6 pad
  • Type “resource motor 5 none” in CLI, ENTER,
  • Type “resouce serial_tx 11 A15” in CLI, ENTER
  • Connect the inverted telemetry signal to S5 pad

(Click to enlarge)


Boot into DFU mode
  • Press & hold the boot button & connect the USB to your computer
  • Then release the button, the FC will enter the Boot Mode

(Click to enlarge)


OSD configuration

(Click to enlarge)


BETAFLIGHT GITHUB
DRIVERS & SOFTWARES
BETAFLIGHT FIRMWARE
Includes
  • 2x LEDs for FC STATUS (Blue, Red)
  • 6x PWM / DShot outputs without conflict
  • 5x UARTs
  • 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Sginal/GND
  • 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  • 1x Side-press button for BOOT(DFU) mode
  • 1x 16pin bottom mounted FFC Slot for FCHUB-6S connection
  • 1x 0.5mm*16Pin 5cm Flexible Flat Cable
  • 4x M3 Anti-vibration Standoffs



Useful Items :


    Product Status : In-Stock

    Best Sellers